cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Forum Posts

ArchiCAD USER Small Office STANDARDS

No where can I find what all large offices with an IT staff have. AC standard set-ups for a small office...one that does mostly houses or project up to 25,000 sq.ft. I understand that a lot can be personal, but.....where does one start, what is there...

Anonymous by Not applicable
  • 1255 Views
  • 1 replies
  • 0 likes

Dumb question re Complex Profiles

How do you remove a Complex Profile from a wall once you have applied a Profile to it? The only choice seems to be to choose a different Profile or choose Custom TIA

another stair problem

can i built this stair from the stair maker in one peace? its not a supported shape. how am i supposed to create it?

Zervas Niokastro 2006 stair.jpg
Anonymous by Not applicable
  • 3942 Views
  • 7 replies
  • 0 likes

Section Cuts with non-right angles

Can a section cut (in version 9) bend? I have a section that I'd like to follow the bend in the building. So half of it would be at 0 degrees and the second half would angle south at say 30 degrees. Is this possible? I know sections can step back, bu...

stair problem

hello there i have a problem with all my stairs. i want the stair to have the lines of the story sensitivity a little bit higher. they are on the 5th tread and i want them on the 8th. do you know how can i change the height of the story cut?

Anonymous by Not applicable
  • 1707 Views
  • 2 replies
  • 0 likes

Unable to edit the slab thickness,box grayed out...

Slab default settings dialogue box in the geometry and positioning tab. I'm not able to change the slab thickness.It is already fixed at 30cm and grayed out. I had no drawing problems before,if so I'll solve it from the help page. Thanks for your hel...

Anonymous by Not applicable
  • 1586 Views
  • 2 replies
  • 0 likes

How do I create a wall that comes to a peak?

How do I create a wall that comes to a peak instead of the default wall which runs straight across parallel to its base? See image: http://www.stevesmallwood.com/pictures/PeakedWall.jpg

Anonymous by Not applicable
  • 1511 Views
  • 2 replies
  • 0 likes

Contour lines and the magic wand

How do i change the heights of the contour lines? I drew splines as cut lines, then clicked the magic wand on them but i cant find anything where it specifies the height. The training guide says "change the heights of the contour lines"....not much h...

Anonymous by Not applicable
  • 13913 Views
  • 21 replies
  • 0 likes

Automatic section markers on elevation

Is it possible to auto reference a section on an elevation? We cut sections on the plan and auto reference them in plotmaker. But we'd like to also auto reference them on the corresponding elevation. Can this be done? I'd rather not have to do them b...

Profile Manager for facade

Has somebody experience with profile-manager to make curved wall? Actually it is impossible to make curved wall with this tool. But I could make with polygon wall.

Anonymous by Not applicable
  • 3315 Views
  • 6 replies
  • 0 likes