cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Forum Posts

AC-24 : Roof Tool not cutting wall the same as Slabs

Why Does the Sloped Incline Tool not cut the walls the same way a Slab Tool does? Here is what looks like a slab interesting the exterior wall. Yet this is a sloped incline. "roof". Why does the wall not get cut the same way a slab would? This compos...

tsturm by Newcomer
  • 590 Views
  • 4 replies
  • 0 likes

Opening Tool

Hello! Is it possible to use the opening tool for roofs? Thx

philigi by Participant
  • 417 Views
  • 1 replies
  • 0 likes

Extruded brick patten

What's the best way to model extruded brick patterning? (in a way that will make adjusting it easier) I've modelled hit and miss brick work as a complex profile before but when I needed to edit the wall I would have to edit the complex profile...

Yvonne by Advocate
  • 447 Views
  • 1 replies
  • 0 likes

Railing on curved stair?

Hi, problem with railing and curved stair. If I show this railing to the architect he would go... What can be done?

eldhead by Newcomer
  • 1070 Views
  • 4 replies
  • 0 likes

Add *only* to selection

It often arises that I need to add to a selection set by using more than one selection box. I hold down the Shift key to add the contents of the second selection box. No problem. However, very often, there are elements from my first selection box als...

Anonymous by Not applicable
  • 449 Views
  • 2 replies
  • 0 likes

separator lines between custom profiles with same material

Hi all, This is probably a really simple question, but how can I show lines between two custom profile beams in section? The elements are both the same material, ie steel profiles, and archicad is merging as if they were a single profile. I need to s...

Anonymous by Not applicable
  • 444 Views
  • 1 replies
  • 0 likes

Resolved! beam junction problem (forced joint)

Hello, 'I have 2 wood beam intersected, they are forced to joint at sharp shape, but I don't want them to joint, but how? normally not all element must be forced to jointed once they touched ? Thanks

Anonymous by Not applicable
  • 538 Views
  • 3 replies
  • 0 likes

Resolved! colume display problem

Hello, columns on G/F project 750mm over 1/F (wood truss), but they can not shown on 1/F, I tried floor plane cut plans, view settings, element setting but not working Please advice Thanks

Anonymous by Not applicable
  • 1140 Views
  • 4 replies
  • 0 likes

Selecting Zones

Embarrassed to say, but a real beginner question: I have trouble selecting the zone stamp to edit the name and the zone to edit the boundary on plan. It seems I can only select the floor slab, which means I usually have the hide the layer on which th...