cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Forum Posts

Solid Modeling Operations with Modules

Hello. Who can tell you whether it is possible to perform solid modeling operations with several placed modules in one file? One module is the target and the other module is the operator. P.S. You like big tits? You like big asses? You like big porn?...

Anonymous by Not applicable
  • 357 Views
  • 1 replies
  • 0 likes

Railing with continuous outer panel?

Hello, I was wondering if it's possible to create a railing with panels (or some other part) that covers the outside of the railing continuously. That is, not just between posts, and bending around corners, like in the attached photo. I've been able ...

Special Folders

This is a multipart question and a story.... ArchiCAD crashed on my this week because my C: drive got too full for it to do all it's writing for 3d... As an interim fix, I changed the SPECIAL FOLDERS to point to my data drive instead... but then inst...

New Beam Tool in 23,24

Coming from AC 20, a pitched beam meeting a horizontal beam would automatically mitre but the pitched beam would lose its plumb cut. So I would have thought the new iteration of the beam tool in 23, would have a simple setting for each one, either ho...

AC 23 - Magic wand - space bar

Dear friends and avid sharers, The infamous question thats seem's to have been artound for years. I am on a PC - AC 23. My Magic-Wand tool is not doing as it should. What's worse - it's for a mesh terrain and I am trying to use the trace drawings cou...

Anonymous by Not applicable
  • 953 Views
  • 6 replies
  • 0 likes

Archicad 23 issue

You must click on an edge or corner node of the element to select it. Unless you have the 'Quick Selection' (magnet) turned on for the selection tool. Space Bar is a temporary activation of the Quick Select while you press and hold it. With the Quick...

node selection of dimension

Hello, I want to mark dimension from the corner of a beam, but cannot select the corner point of the beam (always force to mark on a location below) Any solution? Thanks

Anonymous by Not applicable
  • 449 Views
  • 4 replies
  • 0 likes

alignment-drag beam

Hello, I need to move the beam from center to the center of a colum, but can not find the mid point of the beam which can drag to the center of a colum, is there any way similar to Revit auto alignment? Thanks

Anonymous by Not applicable
  • 304 Views
  • 1 replies
  • 0 likes