Merging two beams different wides
Some times is necessary merging two beams of different wides. Is it that possible with the beam tool or should I use another tool apart from morph. Regards
Some times is necessary merging two beams of different wides. Is it that possible with the beam tool or should I use another tool apart from morph. Regards
As touch screens are getting more common and actually bigger I was wondering If there will be an archicad Versinon able to deal with that technology. and thinking more forward how will it be with virtual / mixed reality. I guess all two technologies ...
I have a situation where otherwise identical unit plans have a 1.5" deep subfloor/leveling layer in the upper stories and no subfloor in ground story. So for walls (which start at sheathing/slab, that is at bottom of subfloor) in modules I thought I ...
Hi, The release notes say the revised curtain wall tool in AC22 can be used for floors and ceilings. Is there any more info on this? It seems that setting 0 degrees for the slant angle is not possible. So that means "sure you can use this tool for ti...
Hi All, What I want to do sounds possible, but not sure how to carry this out or o find out if this is in fact not possible. I have two Pln. files: (Working in AC 21, can not afford to wait for AC22 NZ version) 1 - Apartment block.pln (AB.pln) 2 - De...
Being very new to Archicad, I am looking for some general advice on which tools to use for what. We have walls, slabs, complex profiles, morphs etc. I can have a wall made from the wall tool, a slab, a complex profile or made form a morph. The fact t...
I know I can build a composite floor with all of the material layers (Drywall ceiling below, Joist, OSB sub-floor, hardwood finish). However, for construction drawing dimensions, I don't need the Drywall or hardwood layers when figuring structure: be...
I'm having issues trying to get a handrail end to extend beyond the bottom and top of the stair, not end at the bottom of the stair and top of the stair. The first image shows the segments and nodes turned on. .
Hello, As I already had some great answers from this forum, I would love to share a doubt with you. Is it possible to show the material texture in a 2d drawing (Plan and elevation) ? I already checked this post but it doesn't really answer my questio...
I have tried multiple configurations for the stair settings. I have not been able to force the treads to use up the excess landing that is created. If the treads would move back, there would be more than enough room for the start and end points to li...
User | Count |
---|---|
71 | |
53 | |
18 | |
14 | |
13 |