i noticed that when I'm using the Geometry Method: Polygonal and I've
selected the Perpendicular roof edge. The fascias do not clean up. If I
use the vertical edge it works fine. Is there a work around for this or
am I missing something. See attachme...
I have imported my profile from AC15 to AC16 and there are no menu
options for the Modify Morph sub-menu under Design. I found some older
posts saying that you pretty much have to use the standard default
Command Layout Scheme, and start over with th...
We recently upgraded from AC 14 to AC 16, not sure if this was an issue
in 15 or not but the tick marks for the Special Snap Points have become
these enormous thick lines, have looked but can't find where to change
this, or if its possible.
i have a window set just right. i duplicate it, dragging it over a few
feet along the same wall and something weird happens to the frame. it
jumps out of the casing or flips where the top window of the double hung
is then on the bottom or reversed or...
maybe this is not as hard as i am making it. i need a double, double
hung window, with transom lights above and triple (to match the
horizontals in teh window gang) leaf shutters. like image. i know that
many windows have a transom feature, but it ga...
my plate are slabs, walls go all the way around and at the stairwell
portion the plate is opened up. I have windows that are mid plate and
not punching through the walls on two floors. without making one wall
here, is there a way to make the window p...
I posted this elsewhere as it was the last thread I found that addressed
the Special Menu but here seems like a better place. Has anyone been
able to activate the Special Menu in AC16 on a Mac? Turned it on in
the.plist file (changed it to True) but ...
Is there a way to take all walls, even if they are a different composite
set, and edit their 2d graphic appearance al at once? I would like to
set the end walls, section cuts, weights, colors, mouse holes, etc, all
at once. Same with millwork and oth...
I am wondering if someone can help me out here.... I am a new user of
ArchiCAD so please bare with me I have created a complex profile of our
log wall which works well for my first floor walls but not so well for
gables. When I trim the wall to the r...
