Modeling
About Archicad's design tools, element connections, modeling concepts, etc.
SOLVED!

cannot drag a node of wall corner to a snaoed position

Anonymous
Not applicable
hello, I drew a wall which corner a bit deviates from the grid line (not snaped maybe) , how can I just move the node of this wall coner to thecorrect position? thanks
1 ACCEPTED SOLUTION

Accepted Solutions
Solution
Lingwisyer
Guru
Just disable groups (alt + g) then use the stretch option of the node?



Ling.

AC22-23 AUS 7000Help Those Help You - Add a Signature
Self-taught, bend it till it breaksCreating a Thread
Win10 | R5 2600 | 16GB | GTX1660 

View solution in original post

3 REPLIES 3
Solution
Lingwisyer
Guru
Just disable groups (alt + g) then use the stretch option of the node?



Ling.

AC22-23 AUS 7000Help Those Help You - Add a Signature
Self-taught, bend it till it breaksCreating a Thread
Win10 | R5 2600 | 16GB | GTX1660 
Barry Kelly
Moderator
Start to drag the node, move approximately horizontal and hold SHIFT to constrain it horizontally (or you can use snap guides if you have them turned on).
Then snap to the orange guide line or match the other end of the wall if that is in the correct position (keep holding shift to constrain horizontal).


Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
Anonymous
Not applicable
OK thanks Barry, and Ling