Wishes
Post your wishes about Graphisoft products: Archicad, BIMx, BIMcloud, and DDScad.

Apply to all to turn off by default

jakubc7
Advocate
This is a tiny issue however one that is easily fixed and quite annoying.
When you mitre/chamfer slab of mash edge you can select "Apply to all" option. When you go to chamfer/mitre something else the option is unticked by default ... that's good.

However when you edit the mesh spot heights "Elevate mesh point", you also get an option to "Apply to all".
When you go to do it again down the track, the option is still ticked which may result in flattening your entire site terrain unless you (or your co-worker) realises the mistake early on.

Surely the "Apply to all" should always be turned OFF.
ArchiCAD 10 - 25 | Windows 10
ARCHIcreate | Perth, Western Australia
archicad solutions | content creation | training | software implementation
0 REPLIES 0