Corner window

[Mariano_BAMA]

Hi Everyone,

I checked same of the existing conversations in and around window corner. It seems to me, that it is not possible yet to hendle the two section of a corner window seperately. I meant, they cannot be customazie individually. is it correct? If I am wrong, how can I customize separately? Many thanks in advance.

I tried to select, separately, however any change that I do on one side it applied to the other side as well.

My design goal is to have a corner window joint in the glass, achived, but with a differnt reveal result (my current problem) any advice and/or solution. 

Ideally I need also to add a solid panel section (openable) along the long section of the corner window.

Is it possible and/or to I need to treat again seperately with the window tool?

Many thanks in advance to all

Regards

Mariano

[brakpanpolisie · Accepted solution]

Hi @Mariano_BAMA , see the my attached images and check if this is what you want to show?

I used the Ribbon Window 16, insert it as a normal window, setup the Corner Connection Type as "Glass" (I don't think any of the latest windows can do this??).

So you can have a frameless corner window and both windows in the corner can have different reveal types as per my image.

 

[Mariano_BAMA]

Ps. I hope in the next version of Archicad they will allow to manipulate separately each section of the corner window. It makes more sense.

Thanks again 

[Barry Kelly]

You can if you turn of the corner connection option.

Then each will be a separate window.

You just have to turn on the custom corner and reposition the windows on plan so they join at the corner again.

Barry.

[Lingwisyer]

"...manipulate separately each section"

Isn't this is only an issue if you build the window using the Corner Window tool? I have not used it in ages due to previously having issues with it...

[Barry Kelly]

---

@Lingwisyer wrote:

"...manipulate separately each section"

Isn't this is only an issue if you build the window using the Corner Window tool? I have not used it in ages due to previously having issues with it...

---

Yes, only if you use the corner window tool.

By default the windows are linked, so what you do to one, happens to the other (except for the window length - that is independent).

Turning off the connection is the same as placing separate windows and customising the corner connection.

Barry.

[Mariano_BAMA]

Thanks Barry, for your advise. I will use it next time.

Ps. Sorry to reply you so late.

Thanks again. 🙂

[Mariano_BAMA]

Thanks Lingwisyer, to your participation and comment  🙂