About cuba

cuba · 2024-11-30

cuba · 2024-11-30

cuba · 2024-11-30

cuba · 2024-11-30

cuba · 2024-11-30

Param-o objects are transparent by default, with some parameters and some lines in gdl you can give the objects a fill. x

cuba

I tried tim & connect. The programming just did not take into account that the door can also be opened. funny results

cuba

apparently the door must remain closed to be displayed correctly

cuba

You're not doing anything wrong just close the door, trim the door and open the door again. The doorleaf will be trimmed 

cuba

A Dwg gets placed at his own coördinates and can be far away from the archicad origin. Select all and the fit in window to zoom to the selection. In the manu view/zoom/fit in window

cuba

You should not rotate your workspace, put a north arrow and then rotate the whole model horizontal. Your hatchings will always remain good.

User Statistics

User activity

Convert polylines to fills

Exploded view in Archicad

3d Document + White model render

Truss with the curtain wall tool

Adding fills to param-o objects (parom-o tip 5)

Re: Door leaf isn't cropped by roof (Crop to Single-plane Roof... command)

Re: Door leaf isn't cropped by roof (Crop to Single-plane Roof... command)

Re: Door leaf isn't cropped by roof (Crop to Single-plane Roof... command)

Re: Imported DWG does not show

Re: Same Material but different fill orientations