About kylevfa

kylevfa · 2024-05-10

I've been playing around and watching a lot of tutorials trying to figure out what the ideal railing settings would be to create a continuous smooth curved solid guard similar to the picture below. When trying to use a toprail or handrail and extendi...

kylevfa · 2024-02-20

In our office we typically add building materials with 0" thicknesses to add additional notes to our assemblies. However we have noticed when we set a building material with 0" its building material intersection priority number no longer applies and ...

kylevfa · 2024-01-24

I'm trying to model an interior casing for my windows however for some reason the casing at the bottom is locked to be 2 1/2" wide. If I decrease or increase my casing dimensions all the other sides change except for the bottom. I went through all my...

kylevfa · 2024-01-15

For some reason after updating to Archicad 26, my RCP's are crashing the software when placing them or attempting to view them on the Layout. I've tried updating the most recent build and even tried the open and repair feature. This is happening acro...

kylevfa · 2024-01-13

I noticed that for slabs in floor plan there is an option to change the cover fill orientation to custom distortion however there are no similar options for walls. For our floor finish plan this feature is very helpful as we can accurately indicate w...

kylevfa · 2024-02-22

I contacted support to report this bug and was informed this is not a bug and intersections are operating as intended. The replies can be found below:Hi Kyle,...I'm saying that without volume, there is no bulding material intersection to be computed....

kylevfa · 2024-02-21

Hi Barry,I've went ahead and duplicated the assembly and changed each layer that had 0" to a thickness of 1/32" (which still shows up as 0 due to rounding). With this setup the building material intersections work so it is definitely the zero thickne...

kylevfa · 2024-02-01

Graphisoft support was directly contacted regarding this issue. The Specialist Duncan Gilchrist was very helpful in getting this resolved and has informed me that within Archicad 26 the bottom casing attributes are handled by using the Apron option i...

kylevfa · 2024-01-15

Thank you Barry, figured that was the case sadly.

kylevfa · 2024-01-14

Yes however this is only possible in 3d View which is a little tedious when you have a backsplash tucked behind millwork etc.. Looking for a solution to do this in elevation view instead.

User Statistics

User activity

Model a continuous solid guard

Building Material Intersection display with Assembly

Inside Casing Display Issue

Crashes when viewing a particular drawing on Layout

Custom Cover Fill Orientation for Wall Surfaces

Re: Building Material Intersection display with Assembly

Re: Building Material Intersection display with Assembly

Re: Inside Casing Display Issue

Re: Custom Cover Fill Orientation for Wall Surfaces

Re: Custom Cover Fill Orientation for Wall Surfaces