About Brad Elliott

Brad Elliott · 2025-04-01

I have a project that has been brought up from AC 26. I have added a skylight to the roof and am getting a brick pattern in the roof cut. I have tried various materials as well a basic and composite structures but still have the same pattern.If I tur...

Brad Elliott · 2023-12-23

Problem: Archicad could not be launched because the following add-ons are missing. Interactive Schedule, MEP Modeler, Basic Rendering Engine Except that the add ons are in the noted folder. So now what Operating system used: Mac Apple Silicon 12.7.1 ...

Brad Elliott · 2023-02-24

I have a interior elevation rendering issue happening with BIMx. The tile image used for the elevations renders fine when looked at in ArchiCAD, published pdf's, and even in the BIMx 3d fly through model. However when you go to the BIMx interior elev...

Brad Elliott · 2022-12-15

I'm publishing a BIMx set and one drawing hangs the upload and doesn't publish but allows me to stop the upload. The file that won't upload has it's status as pre-processed. I've tried deleting the document and reloading it but it still doesn't work....

Brad Elliott · 2021-11-11

When I go to publish any document I get a pop up warning that :As a result of the last operation, some stairs have become invalid, will be shown with a color highlight and I can use the built-in "Invalid Stairs" criteria set to find it.Except none of...

Brad Elliott · 2025-04-06

I don't particularly understand it either but it is tied to the GENERAL surface that I am unable to find or modify. It still isn't completely correct because if I select a different bottom surface it still wraps inside the skylight cut but at least i...

Brad Elliott · 2025-04-04

Thanks Barry,That was so close and got me to the answer when I went to show you why it didn't work. I'll give the answer here in case someone else ever has this problem. Also, I'm not sure why your part seems to be acting correctly.In classic ArchiCA...

Brad Elliott · 2025-04-03

Barry, Yes, I had the lining turned off in the 3d image to show that it was overriding the steel material. I have attached two more images. The one shows the lining turned on and covering the brick veneer. The second shows the brick veneer showing th...

Brad Elliott · 2025-04-02

It's Skylight Flat Panel 27 

Brad Elliott · 2024-08-29

I see you are on a Mac. What works best for me is to make the external monitor the one with the menu bar. The Mac then remembers that setting for that monitor moving forward so when you work on the laptop alone it has the menu bar, and when you plug ...

User Statistics

User activity

AC 28 Skylight Roof cut fill default can't be changed

ArchiCAD 26 Update 4 Sorry cannot run on this computer

BIMx Graphics Bug

BIMx File publishing hangs on Pre-processed drawing

Warning- Some Stairs have become invalid

Re: AC 28 Skylight Roof cut fill default can't be changed

Re: AC 28 Skylight Roof cut fill default can't be changed

Re: AC 28 Skylight Roof cut fill default can't be changed

Re: AC 28 Skylight Roof cut fill default can't be changed

Re: Dual vs single monitor setups