Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

Cadimage surface slider

Not applicable
The main door frame of Cadimage surface slider doesn't offset with the door leafs?
The main door frame should be offset and extend where the last door stacks.
Example Images attached
Not applicable
Could you model this using the exterior trim?
Not applicable
Possible, I'll take a look, it should however move the main frame to the outside and not leave it in the wall where regular slider would have it. I don't know how this gets past Cadimage, do they look at real life doors when they code this?

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!