bow seal

[defariaferreira]

Need help

How to create a stamp with the degrees, radius, tangent, base and length of an arc?
View image.

Thank you

[Anonymous]

You could draw the arc as a very thin zero height transparent wall; then apply individual properties and lable it.
Not sure about multiple arrows on a labels on AC23, but in AC22 you would need to manual apply extra arrows.
Hope it helps.

[defariaferreira]

134/5000
thank you
But what I wanted was a bow label that gives me the angle in grads, the radius, the tangent, the base and the diameter

[Anonymous]

All these information can be extracted from the Wall properties and calculated with "Properties & Expressions".

I didn't try it, but I am sure there is a Wall_Radius and a Wall_Angle. Once you have them, its "Just do the math"

i.e.: Create a new property called "Arc Tangent" > Insert in it an expression that calculates the tangent using the Wall_Arc and Wall_Radius > Associate this property to the "fake wall" > Create a label that extract this property > Associate it to the wall.

Then do the same to the other properties.

Hope that helps.