Reveal in Window moves inside when structural display is on "core only"

[Jochen Suehlo]

When I create a simple window and have a profile wall, the reveal of the Window moves inside when structural display is on "core only".
Is there a way to prevent this?
See picture (left side whole structure, right side "core only")

[Peter Baksa]

Yes, this must be done in GDL. Look a the code of "Simple Window Opening": early in the master script

if GLOB_STRUCTURE_DISPLAY <> STRUCTURE_ENTIRE_STRUCTURE then

it reads WALL_SKINS_PARAMS, and sums the hidden skin's thicknesses on both sides, then decides which side to use as an offset.

[Jochen Suehlo]

Thank you Péter for that tip.
With the resulting values of the variables, must I use them in a WALLHOLE command,
or is there any kind of automatism?
If yes and if I still haven't a WALLHOLE, I must add one, I think?

[Peter Baksa]

This must be a bug, the automatic reveal works with a composite wall, it should with a profiled one too.

However there is another problem with this that the WALL_SKINS_PARAMS approach can't fully solve either:
the profile might have a different cross-section at different heights. For complex (and double-slanted) walls this variable contains the data of the skins at the floor plan cutplane (2D), or at sill height (3D).
If you try the automatic reveal in a slanted wall, you will see it is slanted in 3D too, but in a profiled wall it is vertical, so it is a bit unconsistent.

So, coding a custom reveal is necessary to show partial display in profiled walls correctly (assuming the profile is the same cross-section along the position of the window).

[Peter Baksa]

My first comment is kind of misleading, that calculation isn't needed for the reval, as the window's origin is at the reveal plane correctly, and two half-infinite cuts can work.