cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
search
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
License Delivery maintenance is expected to occur on Saturday, November 30, between 8 AM and 11 AM CET. This may cause a short 3-hours outage in which license-related tasks: license key upload, download, update, SSA validation, access to the license pool and Graphisoft ID authentication may not function properly. We apologize for any inconvenience.
Installation & update
About program installation and update, hardware, operating systems, setup, etc.

Plotter setup

Anonymous
Not applicable

‎2006-01-11 05:57 PM

‎2006-01-11 05:57 PM
I have been using Archicad for more years than I want to admit. After taking a couple of years off to build a new home I have finally upgraded my computer and operating system to Tiger and 8.1.1. My problem is that I cannot get my HP Designjet 230 to plot from either Archicad nor Plotmaker. I have the connection through a USB port through a Belkin cable converter to the SCSI cable. Prior to changing computers and 6.5 I was plotting through Microspot plotware. The Plotter is set at 38400 Baud rate.
Any suggestions.
Labels:
0 Likes
1 REPLY 1
Anonymous
Not applicable

‎2006-01-12 07:34 AM

‎2006-01-12 07:34 AM
The easiest thing might be to use an old Mac as a plot server. The Plot Flow program included with ArchiCAD will do the trick. (This assumes you have an old Mac kicking around.) I suspect that a USB to SCSI adapter will bring only pain and frustration. It would probably be easier to buy that old Mac on e-bay if you had to.
0 Likes

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!

Create new topic