Opening line in doors
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-01 09:33 AM - last edited on 2023-05-24 10:44 AM by Rubia Torres
2018-03-01
09:33 AM
While working on a double leaf door I have stumbled upon an interesting discrepancy concerning the door leaf and opening line.
In the attached image I have presented two situations of the same door type. The left one has the Floor Plan display set to
In this case it is crucial since on the floor plan I need the door in an open state in 102cm also on the Elevation/Section the correct length of the leaf.
Anyone has an idea how can this be repaired?
The BIMster @ AllesWirdGut
Currently: Archicad 26
User since Archicad 6.5 (2001)
Currently: Archicad 26
User since Archicad 6.5 (2001)
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-07 07:39 PM
2018-03-07
07:39 PM
Update:
I just got information from Graphisoft Support, that this is a bug in Archicad 21. I did not check it in other versions.
Sadly it concerns most of the doors that I have tested.
For all of you that this might impact your project
I just got information from Graphisoft Support, that this is a bug in Archicad 21. I did not check it in other versions.
Sadly it concerns most of the doors that I have tested.
For all of you that this might impact your project
The BIMster @ AllesWirdGut
Currently: Archicad 26
User since Archicad 6.5 (2001)
Currently: Archicad 26
User since Archicad 6.5 (2001)