Show "active" door on pair of doors?

[Anonymous]

Hi, for a pair of doors (door object D2) on a floor plan, I would like to show which one is the "active" door. Can the door swings be shown differently? If I was hand drawing this, I would show one door fully open and the other one barely open. I have never been able to figure this out......
Thank you.

[Lingwisyer]

Under the Opening Type and Angle... tab of the door settings, you should be able to set the opening angle of each door leaf separately. There is in the AUS doors anyway, not sure about the US ones.



Ling.