Choose your top Archicad wishes!

Read more

CodeMeter key conversion to HID mode failed

Gabor Almasi
Graphisoft
Graphisoft
This article is intended to help troubleshoot an unsuccessful CodeMeter Hardware Protection key conversion process. If you are presented with an error at the end of the CodeMeter key Updating process, then some parts of the conversion were not successful, or the conversion was not successful on some of the license keys plugged into your machine.
  1. Try re-running the installer to make sure that the malfunction of the converter was not caused by a temporary glitch.
  2. Check what requirements need to be met for a successful conversion. After setting up everything that's necessary try re-running the installer.
  3. If all else fails the conversion can also be done manually, without the automated installers. For this please follow the instructions below:

 

Firmware update

For the KEXT to HID conversion, the CodeMeter Firmware version must be at least 2.02. To check your Firmware version and upgrade it:
  • Open CodeMeter Control Center from Applications/CodeMeter
  • Click on your key
  • Check the version, and if it is lower than 2.02 then click the icon next to it to update the firmware
wp-content_uploads_2017_11_codemeter_firmware.png
wp-content_uploads_2016_04_Warning_18x18.png
IMPORTANT: Firmware update might take several minutes, please do not interrupt the process and don't unplug the dongle.
wp-content_uploads_2016_04_Warning_18x18.png
For older CodeMeter hardware keys with a specific controller version, there is no firmware version 2.x, because these controllers do not possess sufficient memory for the changed firmware update procedure that was introduced as part of version 2.0. If you have such a key, please ask your reseller to replace it.

Configuration as HID

    • Open Terminal
    • Type the following command and press Enter: cmu ‑‑serial x-xxxxxxx ‑‑set-config-disk HidCommunication
Where x-xxxxxxx is the serial number of your Hardware key displayed in CodeMeter Control Center Example:
wp-content_uploads_2017_11_hid_config.png
As it prompts in the Terminal, unplug and re-plug the CodeMeter key back in to finish the process.
wp-content_uploads_2016_04_Warning_18x18.png
IMPORTANT: If you convert a NET key make sure to have the borrowed licenses returned before unplug.

Didn't find the answer?

Check other topics in this Forum

Back to Forum

Read the latest accepted solutions!

Accepted Solutions

Start a new conversation!