Morph and story

[Anonymous]

Hello!

I have a bunch of geometry in rhino drawn from z=0. So that when I send it to archicad the geometry ends up as morphs at sealevel or that is elevation 0.

The weird thing is that instead of just putting the geometry at 0 and setting the morphs home story to 0 it sets it to x and then adds a big +/- offset. I cant figure out where this comes from. The offset and story it is set to also changes! Look picture to see.

I cant see any way of using the grasshopper story setting with morphs.

Any help greatly appreciated!

[Anonymous]

I tried tampering with the morph story settings in archicad(setting to lvl 0 with 0 offsett) then starting up grasshopper again. The funny thing was that it didnt go to 0 or story 3(which was the story it had before) but it sent it to story 8! hehe.
Really really weird!

[leceta]

Martineide, I have not idea why is happening this, but consider seriously the possibility of a bug. This software is still in a very early phase of development.

[Anonymous]

Thanks. Yes I guess... ive posted this some other places and im not getting any answers! 😃

[leceta]

yes, it´s frustrating...