2009-06-05 06:02 PM - last edited on 2023-05-11 01:18 PM by Noemi Balogh
2009-06-05 11:37 PM
JoeyCAD wrote:Glad you answered your own question in step 1. The coordinate message will be seen if the picture is distorted in any way - for example, taken with a wide-angle lens. There is no way to map undistorted geometry (your model) onto a distorted photo. Various old discussions on these forums you might search out discuss using Photoshop filters to correct the photo so that the model will place better.
Edit: placed the drawing using the figure tool and it's recognising it now, but everytime I place the 6 points it says 'unable to place camera! check entered data or try with different points'
Any clues what's wrong this time?! (I'm assuming something simple again, haven't had chance to use this much, so any help would be appreciated!!!)
J