CADIMAGE Garage door
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2020-01-24 02:03 PM
‎2020-01-24
02:03 PM
1 REPLY 1
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2020-01-28 05:16 PM
‎2020-01-28
05:16 PM
Good question! The door really shouldn't do that, very difficult to open I would think. We'll fix this ASAP.
In the meantime you can work around it by setting the 'Door Side Room' to a negative value. This will make the door narrower. If the frame width is 30mm, set the 'Door Side Room' to -30mm.
In the meantime you can work around it by setting the 'Door Side Room' to a negative value. This will make the door narrower. If the frame width is 30mm, set the 'Door Side Room' to -30mm.