cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

Hatches of Mesh in Section do not translate to Autocad

Anonymous
Not applicable
When Exporting through a translator using "Save layout into paper space with Full View's Content", the hatch (in this case Earth hatch) that is visible in Archicad when vertically sectioning through the ground mesh, disappears in Autocad.

If exporting to "Paper space with Drawing as blocks" or "model Space" (i.e. without xref's), it translates fine.

We need to generate Construction Documents for sharing with consultants that show these hatches.

Any ideas?
1 REPLY 1
Daniel Kovacs
Graphisoft Alumni
Graphisoft Alumni
Dear MilesHartog,

I have tried to save a simple mesh section with similar settings, but the fill saved fine for me. I suspect there might be something special about your project that causes this. Can you send me a PLA version of your project so that I can take a look?

I contacted you in a PM, we can exchange files through there.

Regards,
Daniel Alexander Kovacs

Professional Services Consultant

GRAPHISOFT



For Troubleshooting and useful Tips & Tricks visit