Junction on a placed MEP element

[Conrado Dominguez]

While placing a T in the middle of a pipe run, the program response is to show the space where the T should appear, that is, it shows the gap in the pipe but not the T.
However, examining the work in 3D, show the work correctly.

Also, if I try a new file, MEP behaves correctly.
Any clues to remedy this ?

Thanks for your response

[David Maudlin]

Conrado:

You can compare the Floor Plan Display > Show on Stories settings be tween the visible and non-vivble parts. It could be the default setting of the Pipe Tee in the file you are using that is the issue. This might relate to the Floor Plan Cut Plane setting.

David

[Conrado Dominguez]

Thanks David.
That was the problem.

Lack of sleep turns us into beginners again!!