About Conrado Dominguez

Conrado Dominguez · 2023-07-03

Reviewing drawings before publishing I found a missing View information.The view and its Layout are displaying only a Section Marker.Looked back at the Project .back-up folder shows the View and Layout correctly.What may cause the View dissapear ?Is ...

Conrado Dominguez · 2023-07-02

I figure I am missing something basic but I am going NUTSThe images below show a simple composite wall coming together at a cornerThey do not clean up in plan.but look great in 3D.Any clues will be appreciated

Complex profiles corners · 2023-06-27

Using a complex profile (Foundation wall) in a continuos manner, or using two separate walls and then intersecting them do not show a clean corner., they show an ugly overlap of both, the wall portion and the footing edges belowUsing AC25 and out of ...

Conrado Dominguez · 2022-06-11

I will not loose sleep about this, but I wonder why?1. The Basic Block 25 library part > Kitchen cabinet settings > Representation, trying to Hide the Counter edges show the Hidden contour line of the Object, it does not displayed, blank, without the...

Conrado Dominguez · 2022-06-06

I tried to reply to thank for the advise received and the result is the message as shown belowAny suggestions ?

Conrado Dominguez · 2023-07-23

I would state the size of the skylight (rough opening) with an attached note to its 2D image in the roof plan and place dimensions from the center of the skylight to other close roof elements ( roof edges, grid lines, adjacent walls trhu the roof, et...

Conrado Dominguez · 2023-07-04

Thanks for looking into thisUnfortunately the Layout of the missing view was also a blank page.Since I have a back up in good shape (saved under s different .pln name) I'llcreate a single PDF from there and group it with the PDF's from the the projec...

Re: Complex profiles corners · 2023-06-29

Barry,Layer Intersection priority was 0Changed to 1 and the problem was solved

Re: Complex profiles corners · 2023-06-29

Problem solved.The Layer intersection Priority, which I never heard about, and I finally found was 0Once I turned to 1, the complex profile placed in that Layer intesrsected correctly.Thanks

Re: Complex profiles corners · 2023-06-28

Barry,The Complex Profilel cheked to be use as Wall does not have any setting for group intersect priority.The Clean Walls & Beams at the View Options is turned on.The complex wall setting EDIT does not show any setting for intersect priority.Corners...

User Statistics

User activity

Missing View

Walls Intersection

Complex profiles corners

AC 25 Casework - Kitchen Cabinet behavor

Forum problem

Re: Skylight Dimension on slope roof

Re: Missing View

Re: Complex profiles corners

Re: Complex profiles corners

Re: Complex profiles corners