Standardized Details in 11 and How to Retrieve Them
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007-09-07
12:54 AM
- last edited on
2023-05-30
12:24 PM
by
Rubia Torres
2007-09-07
12:54 AM
We have a set of standard details saved as PMKs, but they obviously don't work in 11.
In what format should I store my standard details so that I can import them into a new job, and then tweak them a little so they match this new job's specifications? When I import my old PMKs or any DWGs, I have to explode them and pretty much redraw them.
Isn't there an easier way? How are you all setting up your standard/basic details? Do I really have to create all my details from scratch for every new project?
In what format should I store my standard details so that I can import them into a new job, and then tweak them a little so they match this new job's specifications? When I import my old PMKs or any DWGs, I have to explode them and pretty much redraw them.
Isn't there an easier way? How are you all setting up your standard/basic details? Do I really have to create all my details from scratch for every new project?
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007-09-07 01:09 AM
2007-09-07
01:09 AM
Here's a very good article on this topic: Detail Libraries
Richard
--------------------------
Richard Morrison, Architect-Interior Designer
AC26 (since AC6.0), Win10
--------------------------
Richard Morrison, Architect-Interior Designer
AC26 (since AC6.0), Win10