printing to a KIP 3000

[Anonymous]

Whenever I print to a KIP 3000, crosshatching does not print correctly (i.e. a tile floor in a round room prints out segmented instead of complete coverage.) This could be a deal killer to my company...Please help!

[Anonymous]

Sorry I couldn't give you more to go on but at least I know, thanks to you, that under the right circumstances it is possible to make this work. Hopefully I'll figure out the magic words! One last thing; Whenever you set the KIP up as a plotter, what port number did you use?
Thanks Tom for all your help. You could teach KIP tech support a thing or two.

Lee

[TomWaltz]

lhendrix wrote:
Sorry I couldn't give you more to go on but at least I know, thanks to you, that under the right circumstances it is possible to make this work. Hopefully I'll figure out the magic words! One last thing; Whenever you set the KIP up as a plotter, what port number did you use?
Thanks Tom for all your help. You could teach KIP tech support a thing or two.

Lee

On our network, it's port 9102