Door and window builder - urgent problem

[Anonymous]

Hi all

Not sure if anybody has come across this before, or whether it is just on the workstations in our office.

Problem -

Once a window has been created in DWbuilder and inserted into the model, and then it is selected with a view to amending, the DWbuilder dialogue is not accessible. Therefore the only way to change the window is to recreate, which is very annoying when dealing with a lot of different windows.

Hope this is clear, and if anybody can help it would be greatly appreciated.

Thanks

Tom

[Anonymous]

Thanks

I found it in the end!!!

I am looking back at our purchase agreement to check what numbers were covered, hopefully this will help.

The file/activate cadimage shows a net keyplug, but under the installed add-ons there is nothing....does this have any bearing on the registration for each workstation?

Thanks

Tom