Door 'cavity closure' question

[Ignacio Azpiazu]

In a wall with four layers, I set it to 'Turn in 1 skin' (the outside layer). It turns around beautifully, stops short of the interior gypsum board which let's say it's OK, but actually overlays over the two intermediate layers (that is, through the turned around exterior skin I see the the continuous intermediate layers).

Any idea what's going on here? Is it the pens?

[Anonymous]

Assuming you're talking about a composite wall, does the composite skin in question have a background fill or is it set to pen 0 (i.e. transparent)?