demolitions and reconstructions
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-10-10
04:28 PM
- last edited on
2023-05-26
11:42 AM
by
Rubia Torres
2005-10-10
04:28 PM

3 REPLIES 3

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-10-12 09:51 AM
2005-10-12
09:51 AM
what I do is cut the wall and change the bit to be demolished into a demo layer and give it a different fill and dashed line. Then when I have a sheet for the new work that layer is turned off ( as it has been demolished!).
Basically I have three layers.
existing
demolished
and new
So, if I have a door to demolish I demolish the part of wall that contains the door.
This of course "demolishes" the part of the wall over the door but unless I am doing quantities that probably doesnt matter that often. If that is an issue it just gets a bit more complex.
Basically I have three layers.
existing
demolished
and new
So, if I have a door to demolish I demolish the part of wall that contains the door.
This of course "demolishes" the part of the wall over the door but unless I am doing quantities that probably doesnt matter that often. If that is an issue it just gets a bit more complex.
Cheers John
John Hyland : ARINA : www.arina.biz
User ver 4 to 12 - Jumped to v22 - so many options and settings!!!
OSX 10.15.6 [Catalina] : Archicad 22 : 15" MacBook Pro 2019 [/size]
John Hyland : ARINA : www.arina.biz
User ver 4 to 12 - Jumped to v22 - so many options and settings!!!
OSX 10.15.6 [Catalina] : Archicad 22 : 15" MacBook Pro 2019 [/size]
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-10-12 11:15 PM
2005-10-12
11:15 PM
Project Framework also suggests that you explode the demolished items to 2D elements to avoid intersection issues (or at least it used to, haven't seen one for AC9 yet).

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-10-13 01:32 AM
2005-10-13
01:32 AM
s2art wrote:Yes Make sure the demolished layer has a different layer number for intersections
Project Framework also suggests that you explode the demolished items to 2D elements to avoid intersection issues (or at least it used to, haven't seen one for AC9 yet).
Cheers John
John Hyland : ARINA : www.arina.biz
User ver 4 to 12 - Jumped to v22 - so many options and settings!!!
OSX 10.15.6 [Catalina] : Archicad 22 : 15" MacBook Pro 2019 [/size]
John Hyland : ARINA : www.arina.biz
User ver 4 to 12 - Jumped to v22 - so many options and settings!!!
OSX 10.15.6 [Catalina] : Archicad 22 : 15" MacBook Pro 2019 [/size]