Yes, for me, remembering is the problem.
Here's a typical scenario:
I'll fillet these 2 lines which don't quite join.
Oops - error. They won't fillet. Further investigation shows that one of them's a polyline. Explode the polyline. Try again.
Oops - error. Now the polyline's a group. Turn off grouping. Try again.
Success! Next!
Copy this section of the drawing over here. Now move that group.
Oops - it's no longer a group.
I forgot to turn grouping back on. Undo. Undo. Undo.
Turn grouping on. Do the copy again.
Success! Phew!
Link wrote:
You can use the Selections palette (Window>Palettes>Selections) for this.
Yes, but I'm trying to figure out why other people make so many groups on their drawings - which I then have to edit!