Make wall stud different from the bottom plate?

[Anonymous]

hello!

I have made a construction drawing of the wall studs, but how can I make the wall studs to have a "wooden look" overview ( see the file below).

How to do it on ArchiCad?

[Barry Kelly]

I deleted your duplicate post in the student part of the forum if you are looking for it.

If you used a column for the studs all you need to do is use a cut fill with the hatch pattern that you require which you can set in the column settings.

If this is all 2D then the studs can be a fill with the required hatch pattern.

Barry.

[Anonymous]

Thanks!