Section doesn't show skin separator lines

[Anonymous]

I can't get the skin separator lines to display in my sections. What am I doing wrong?

The attached image explains it best, I think.

[Erika Epstein]

In general, Check over-ride fills and then you will have this option available.

I am not sure which wall you are unhappy with.

[Anonymous]

None of the separator lines are showing, so it's all of them that I'm unhappy with. I've tried every variation on Model View Options with no luck.

[Rod Jurich]

LINZ wrote:
/.. What am I doing wrong? /......

Lindsay, you need to have a different name for the finish skin to show the separator line.
If the finish skin is to be the same fill as the core you will need to have a
different named fill, core fill 1, core fill 2.

[Anonymous]

Thank you very much! I didn't know that was the case...