stair issue

[sarahric]

I'm having a lot of problems with the stairmaker tool.
I create a stair, set my requirements - floor to floor height, tread & riser, no of steps, but when I go to 3d, elevations and sections this error occurs.
I've tried creating new stairs and it keeps happening

[Barry Kelly]

It is not a problem with the stair geometry.
You are simply missing a fill that it is trying to use if ever the stair is cut in section.

Open the stair properties and look at the section fill.
If it is 'Missing' then choose a new fill.

Barry.

[sarahric]

Thanks Barry,
I wish it would just say that!