Grasshopper Rhino7 does not reference AC 25 Geometry

[sondermann]

Hello,

I have connected my AC project with Grasshopper successfully. However, Grasshopper won't reference AC Geometry.

E.g. when trying to set one AC Morph in a Grasshopper AC Morph Parameter component (Rightclick-menu) Grasshopper/Rhino3D won't switch over to AC to allow me picking a Morph.

I act exactly like in older versions where everything worked properly.

I can tell both AC and GH are connected properly because the GH AC-component doesn't show up red.

I use AC 25 INT Edu with Rhino7 Grasshopper on Mac (Big Sur 11.6), each running the newest version available.

Any hints why this doesn't work are highly appreciated.

Best, Horst

[Minh Nguyen]

Dear Horst,

Thank you very much for the question and I am very sorry for the experience!

If I may ask, if you drop an Input component into the Grasshopper canvas while the connection is made, and right-click for selecting, does it open up a menu like this?

Best regards,

Minh

[sondermann]

Hi Nguyen,

no, this does not open, although the connection is seemingly running.

Best regards, Horst

[Minh Nguyen]

Dear Horst,

Thank you very much for the confirmation!

I would like to ask for your help with this one. Our developer created a special add-on for the investigation. I will reach out to you for further intruction.

Best regards,

Minh