Default Line Settings Changing

[Anonymous]

I was at work today doing some very tedious line work (2D). I wanted all the line work to be on the same layer, however, the default setting I set for the layer of the line would not stick. Sometimes two or three times it was okay. After that it defaulted to a layer I did not ask for, What's the problem?

[Anonymous]

I cured this problem by moving from AC17 to AC18. Touch wood it did not re-occur in 18, I am just switching to 19 & if it happens in that I will go back to 18.

It was so annoying, it would be worth an upgrade fee just to get rid of it.

[Katalin Borszeki]

Hi all, We’ve contacted Rogerdodge and Rippledesign, but unfortunately we couldn’t get sufficient information to reproduce the issue.

[Anonymous]

I had a short gotomeeting screen sharing with Akos Karocczkai a technical support engineer this morning and have sent him some information to look into it a little further. It does appear to be an issue stemming from keeping settings from previous archicad versions. When I opened a new AC 17 file and used all the default settings and template the issue wasn't present. From now on I intend to have all shortcuts, templates, etc. that we use in our office built from scratch to make sure we don't have a leftover glitch. In any case, no issues in 18 or 19 for now.