Hello,Me and my colleague did some digging and thus far came to a
conclusion that it is impossible to make interior elevations section
lines visible to print same way as with basic elevation tool? I'd very
much prefer if we were wrong about this but ...
I can agree the IE works sometimes in mysterious ways but so far it has
been a minor inconvinience and I hope it stays that way. We opted the
.PMK model to lighten the work models, for ease of document management
and allowing to "outsource" the print...
Thank you for you proposal.While this would be likely workable option in
other, smaller context the reason we opted for the interior elevation
was the option to use automatic naming via zones that doesn't seem to
work with seperate elevations? This i...
nbalogh wrote: Hi prot158, Thank you for your feedback. I'm so sorry you
still experience the issue. Can I invite you to a private message to
investigate your issue? Kind regards, Noémi Hello! I'm experiencing same
issue. We are working on with versi...