Informationen zu ezeehoon

ezeehoon · 2025-02-11

I have an another three wall connections question. I understand that the reference lines need to meet at a single point. How should I approach modeling the 'as-built' condition, where the critical dimension for the exterior wall is taken from the out...

ezeehoon · 2025-02-10

Hi, this is my first post. Thank you in advance. I want these three walls to connect cleanly. Please see attached image below for the exterior blue walls and the interior red walls .

ezeehoon · 2025-02-12

Thank you. I used the Display order technique. 

ezeehoon · 2025-02-10

As you can see, I am redrawing very old documents where all the exterior dimensions are measured to the exterior finish, and all the interior walls are measured at the center points of the walls. Thanks for your help!

ezeehoon · 2025-02-10

Thank you. As mentioned in my reply to Lee Hankins above, my 3 reference lines do not meet at a single point. Is there a way to trim the three walls like attached image while their 2 exterior reference lines meet at one point, while the reference lin...

ezeehoon · 2025-02-10

Reference lines for walls Exterior wall Composites Interior Wall Composites

Benutzerstatistik

Benutzeraktivitäten

Interior wall trims on angled exterior walls

Three walls connection

Re: Interior wall trims on angled exterior walls

Re: Three walls connection

Re: Three walls connection

Re: Three walls connection