About catalinpopa

catalinpopa

Hi everyone, I'm an architect from Romania and I've been building a small add-on for a problem I kept running into: checking vehicle swept paths — fire-engine access, roundabouts, parking manoeuvres, garage ramps — without leaving Archicad. WHAT IT DOES - Swept Path (from Se...

catalinpopa

Hi! I m working on it. I think this week it will be done

catalinpopa

claude is also working on this, what s the difference?

catalinpopa

@Lingwisyer — that's exactly the gap I'm targeting. The CI and GS objects handle a single clean maneuver well enough, but flowing turns and multipoint are where everyone ends up drawing over the output by hand. Continuous path following and multipoint sequences are the core ...

catalinpopa

Thanks, and yes please. Parking areas are the best possible test case, since that's where the multipoint and clearance issues actually bite. If you can share a couple of real parking layouts you've had trouble validating, that would help me make sure the solver handles the a...

catalinpopa

@Miha Nahtigal — fair point, and you're right that turning curves themselves aren't new. The reason for an addon rather than a GDL object comes down to what GDL can't reach:A GDL object can only see its own parameters. It can't read a polyline you drew in the plan, follow it...

User Statistics

User activity

ArchiTurn (beta) — swept path analysis directly in Archicad: does the vehicle fit or not?

Re: ArchiTurn (beta) — swept path analysis directly in Archicad: does the vehicle fit or not?

Re: Archicad AI Pilot— MEPbridge ACAIstr | Version v0.1.2 Release, Read/Write & Automation Valid

Re: ArchiTurn (beta) — swept path analysis directly in Archicad: does the vehicle fit or not?

Re: ArchiTurn (beta) — swept path analysis directly in Archicad: does the vehicle fit or not?

Re: ArchiTurn (beta) — swept path analysis directly in Archicad: does the vehicle fit or not?