I have the same wall types in this model. Specified both of them with
the same parameters in everything, same thickness, yet they are
obviously, not the same thickness?! Very frustrating. Any help would be
much appreciated, thank you.
My roof cutout deletes walls connected to top by, "trim" command. Any
advice on how to replace walls? Or achieve same desired without without
this problem? Thank you.
Mahmoud, thank you! Yes, your solution worked absolutely, 100%.I
disconnected all the walls from the roofs. I then subtracted the roof
polygon, THEN split the walls from where they would attach to different
roof areas (portion below the upper walkway...
