The custom drawing titles I use have started to show ALL drawing titles
on the layout, not just the individual drawing titles. This is even
after I recreated the custom title in ArchiCAD 25 and followed the
ArchiCAD instructions for doing so. If I ha...
I've been trying to create a simple interactive schedule that summarizes
exterior walls in a certain way. I'd like it to show the gross wall
area, the total area of any windows within that wall, the total area of
any doors within that wall, and the n...
After reading this article, I downloaded from ArchiCAD Goodies the
Interior Wizard and Accessories. After successfully installing it,
restarting my computer, loading the libraries, and restarting ArchiCAD,
I selected a zone and went to Design > Desig...
I would like to somehow change the ArchiCAD 18 Zone Stamp so that the
scale sensitivity is different. Instead of the 1:50 scale limit, I would
like to make this 1:30 or 1:32 so that a stamp that appears on a drawing
at ¼" to a foot is different than ...
I've found a mystery that so far occurs predictably but only on one
ArchiCAD 17-created project. When I place a PDF text block on a layout,
it comes in as a 2" x 2" blank square that can't be updated or read.
Opening it, I find the note that it was l...
Barry, good tip. The baseboard that didn't show up on the Interior
Elevation view showed up as expected using the standard Elevation
approach. This seems to be a bug with the Interior Elevation tool and
I'll let Graphisoft know. Thank you.
Barry, thank you for the thoughts. It does not appear to be the same
issue you had, and I did check to see if everything was there in wire
frame. It looked correct, so I'm still trying to figure out why the
element doesn't show in elevation.
Thank you for the reply! When I disabled the surface override, shadows
appeared normally. I realized that the override material had an Emission
number of 0 and a color white. When I changed the color to a medium
grey, the shadow appeared even with th...