Hello.I want to show a very depressing modeling error. For example - I
have the wall and I want to create the hole under of part of wall (at
the same time, I do not want divide the wall into 2 parts and change
priority layers or materials).Under the ...
I can change the height of the whole sandwich. But I can´t change the
height of each layer separately (down or up). Why?Please, apply this for
the walls, roofs, plates (floors) etc. Apply for all directions (cuts
and groundfloor). Thank you very much...
Good morning, Barry.Yes, I know about this, but... that is the
problem.Your picture 1 and 2 must be the same case. Because what you see
in the 3D model - must be see in 2D (in all 2D drawings - cuts, views,
floor plans etc.).And the most important th...