Incorrect behavior of the Z mark in the tracking display when editing the Z mark of a pipe elbow in the plan. You move to Z, enter the coordinate, then use the arrow to move up to X, and then back to Z; at this point, the Z is reset and the entered value is not saved. Even w...

When trying to label the MEP parameter of a pipe that is perpendicular to the cut, Ac crashes. However, this does not happen with pipes that are parallel or at an angle. I have attached a video.Ошибка MEP.mp4 Operating system used: Windows 11 24H2

I found an error when I changed the pen group by activating the default pen replacement for the equipment, and the equipment dimensions changed as shown in the video.Обнаружил ошибку когда при групповом изменении пера активируя замену перьев по умолчанию оборудования, изменя...