I wonder if you are navigating using the Tabs? If so, are you are aware that a single click on the tab is sort of like switching using the Project Map, and that you need to
double-click on the Tab to get the View to update completely?
Nope, i was navigating using the view map on the project navigator by double clicking on them.
I'm sorry if i was a little bit unclear, but the problem is not about settings not being updated when i was switching from one view to another.
The problem is, when i tried to "clone a folder" my camera set, the camera set would be cloned in the view map, but all of the cameras in the set would not maintain their original view.
They were all just looking at the same view.
Thank you Richard for your reply, and the tab click that you mentioned is another AC 20 tip worth knowing