Documentation
About Archicad's documenting tools, views, model filtering, layouts, publishing, etc.
SOLVED!

Comma in Dimension?

Anonymous
Not applicable
How do I get rid of the comma in the DIMENSION? All my DIMENSION suddenly have a comma. I don't know what happened.
1 ACCEPTED SOLUTION

Accepted Solutions
Solution
Barry Kelly
Moderator
As far as I know that is an Operating System setting.
So unless you changed something there recently it should not have changed.

The problem with this is if you turn it on/off then it may be different if you open the same file on another machine.
Turning the comma off will not affect existing dimensions, so you will now get a mix.
At least this is what used to happen years ago when I looked at it.

Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11

View solution in original post

2 REPLIES 2
Solution
Barry Kelly
Moderator
As far as I know that is an Operating System setting.
So unless you changed something there recently it should not have changed.

The problem with this is if you turn it on/off then it may be different if you open the same file on another machine.
Turning the comma off will not affect existing dimensions, so you will now get a mix.
At least this is what used to happen years ago when I looked at it.

Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
Anonymous
Not applicable
thx Barry Kelly ,Can be set inside the control panel, I have successfully eliminated the problem. enjoy