Document & Visualize forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Elevations display

Tom Krowka
Booster
I have exterior trim profiles on a project that is quite detailed; a couple of curves and overlaps of material. When generating the elevation at 1/4" scale the trim comes out as almost a solid line due to the number of changes in the face of the trim profile. Is there any way to delete (or lighten with a different pen number) the in lines in the face of the trim profile in elevation, other than the global elevation setting for uncut elements.
Thanks. (V23)
Tom Krowka Architect

Windows 10, AC Version 25

Thomas@wkarchwk.com

www.walshkrowka.com
2 REPLIES 2

This can happen if you drew the curves for a complex profile using the Magic Wand rather than arcs. If so, you might try redrawing the profile with arcs. Or, you might consider selecting the trim and converting to Morphs, which gives you more control over the display of curved edges.
Richard
--------------------------
Richard Morrison, Architect-Interior Designer
AC25 (since AC6.0), Win10

Tom Krowka
Booster
thanks for that heads up also. You da man!
Tom Krowka Architect

Windows 10, AC Version 25

Thomas@wkarchwk.com

www.walshkrowka.com

Start a new conversation!

Labels

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!