Roof angle changing hatch output

[Anonymous]

A quick query: I have two roofs, one set at 5 degrees, the other at 15. Both of their fill settings are exactly the same and the drawing display options are correct. However, the 5 degree roof hatch appears to scale independently and plots out as a 25% fill. See attachment. Any suggestions would be greatly appreciated.

[Anonymous]

It seems to sort itself out in V13 if you change the 'Edit Vectorial Patter' to 'Scale with Independent'. Look towards the bottom of the screenshot.

[Barry Kelly]

George wrote:
It seems to sort itself out in V13 if you change the 'Edit Vectorial Patter' to 'Scale with Independent'. Look towards the bottom of the screenshot.

That is it George.
I see my fills are scale independent now but when I look back at an old template they used to be "scale with plan".
Tracking back through my notes I see i did indeed make this change.

Thursday, 14 June 2007 4:36 PM
"Custom orb cladding - vertical" fill type change to not be scaled to avoid elevation / zoom bug.
NOTE - if used as a polygon fill then it will no longer scale.

So that is indeed the solution.
Barry.