Archicad 10 launching problem! URGENT help needed

[Anonymous]

Since yesterday something funny has starated to happen. When i launch Archicad 10, the Graphisoft bug reporter launches and refuses to go even after cancelling as well as sending the report, the Archicad 10 does not launch. Everytime it goes back to the bug reporter and it quits.

[Srinivas]

just4you0 wrote:
Since yesterday something funny has starated to happen. When i launch Archicad 10, the Graphisoft bug reporter launches and refuses to go even after cancelling as well as sending the report, the Archicad 10 does not launch. Everytime it goes back to the bug reporter and it quits.

Are you working on a student/Comercial version? Where are you located in India?

cheers,
Srinivas

[Anonymous]

I have been working on the student version, but a friend of mine who has a commercial version has started behaving in the same manner. The ArchiCAD 10 does not launch anymore it always goes to the bug reporter and it quits. Any solution to this?

[Gorazd]

First tought would be to try and reinstall Archicad. Usually that helps. Was there any change in hardware or did you install some new software that might mess something up?

[Srinivas]

just4you0 wrote:
I have been working on the student version, but a friend of mine who has a commercial version has started behaving in the same manner. The ArchiCAD 10 does not launch anymore it always goes to the bug reporter and it quits. Any solution to this?

If the reinstallation doesn't work, then try to change your default printer, if its possible try to delete your printer [this is recommended if you can reinstall the printer drivers again] and start ArchiCAD. You can reinstall ArchiCAD after deleting the printer.

Hope this helps.

[Djordje]

Just a hint to all Indians:

Please put your location in India in your profile too. That way, you could communicate among yourselves if you are geographically near.

And if you are far, in India it is really far away ...

[Rafal SLEK]

Clean also Graphisoft folder from Documents and settings sometimes it helps in such situations - there are located prefs files which are loaded on start.