Interactive Schedule

[Red]

I'm having problems setting up a schedule with this criteria.

Basically I'm wanting the schedule to only select certain objects and list the following.

1. Objectname (only certain objects not everyone that is in the drawing)

2. Layer of that object

3. Story that the object is on

4. ID of the object

I have no use for any of the parameters within the objects.

[David Larrew]

Red wrote:
Basically I'm wanting the schedule to only select certain objects and list the following.

1. Objectname (only certain objects not everyone that is in the drawing)

2. Layer of that object

3. Story that the object is on

4. ID of the object

It is possible...

1. Set "Object Type" and "Object Name" under the "General" tab.

2/3/4. Select (check) "Layer", "Floor (Story)", and "ID" under the "Fields" tab.

[Red]

Under the general tab how do you set it up to look for certain objects. I see where you can go into additional parameters and have it look at certain objects parameters.

[Red]

After a few minutes of pulling my hair out I figured it out. Thanks David for your help.

[Red]

Unless I have overlooked it can you also have it to show the objects link?

[Karl Ottenstein]

Red wrote:
Unless I have overlooked it can you also have it to show the objects link?

By link do you mean the path in the file system to the actual object (or the PLA containing it)? If so, nope, AFAIK there isn't a way to show that.

Karl

[Red]

Im referring to the link for BOMs. (Properties)