RAID 0

[Anonymous]

Has or is, anyone using a Raid 0 setup (with m2 nvme) drives ?
with any success ?

[Lingwisyer]

Someone did a review of it over on eteknix a while back. Basically says that you will get a decent improvement in your read and write performance but at the cost of increased latency. Also, the rest of your system might bottleneck the performance in which case you will get the latency without the performance...

https://www.eteknix.com/year-nvme-raid-0-real-world-setup/



Ling.

[Anonymous]

Why not use a ramdisk??

[Anonymous]

Risky setup for marginal real world performance gains, I don’t think you’d get any noticeable performance gain in ARCHICAD and possibly a decrease in performance due to latency and RAID overhead.
I’d only look at RAID 10 for anything with project data, no redundancy in RAID 0, but I don’t know of any motherboards with 4No M.2 slots required for this.

Scott