missing macro for double hung window
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2016-04-08
10:40 PM
- last edited on
2023-05-24
12:30 PM
by
Rubia Torres
2016-04-08
10:40 PM
Is there a way I can get the missing macro? and where would I place it since the macro files are container files?
Thanks
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2016-04-09 02:56 PM
2016-04-09
02:56 PM
Douglas:
Check the error message again, it probably says FILL not found. You will need to go through the parameters for the double hung window and find where there is a MISSING or ? for a Fill selection.
You should add a Signature to your Profile (click the Profile button near the top of this page) with your ArchiCAD version and operating system (see mine for an example) for more accurate help in this forum.
David
Check the error message again, it probably says FILL not found. You will need to go through the parameters for the double hung window and find where there is a MISSING or ? for a Fill selection.
You should add a Signature to your Profile (click the Profile button near the top of this page) with your ArchiCAD version and operating system (see mine for an example) for more accurate help in this forum.
David
David Maudlin / Architect
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14